Re: How can I access the TINI IO Ports
Jing Qiu <kevin_jing_qiu-FFYn/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Thanks. I want to connect an LCD to the DSTINIs400 socket, but as you said, there's only a few IO port pins available. I see there are 32 user parallel IO pins available. How to use these user PIOs to access the data/address/control BUS? --- Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]> wrote: > Jing Qiu wrote: > > I'm using DSTINIs400 socket, could anybody show me > > where's the TINI IO ports, as I couldn't find them > on > > the datasheet. > > Look for pin names such as P0,P1,P2,P3,etc. Some > ports are not > accessible as they are used for address/data/chip > enables. > > -- > -- > Bryan Armstrong > bryan.armstrong-6tN4nzCoH/[email protected] > > ______________________________________________________________________ Post your free ad now! http://personals.yahoo.ca _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini