RE: How can I access the TINI IO Ports
Bruce Boyes <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
At 11:28 AM 3/11/2004 -0500, Jing Qiu wrote: >The problem with me is that I couldn't find anywhere >to connect my LCD to the TINIs400 socket. Most of the >IO ports are used to chip select/enable signals, and >there are only Port5 and Port1 have some pins out on >the socket. I wonder is it possible to interface it >using the parallel IO pins on the socket? There isn't a way to just plug an LCD on. This is part of the reason we made SBX2, which works with the Dallas TINI390 module and our STEP board. You can just plug on an LCD, keypad, and you get 24 bits of rugged high-sink I/O, another UART (RS232/485/IrDA), etc: http://www.systronix.com/expansion/sbx2/sbx2.htm Bruce _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini