Re: Power Supply

Bruce Boyes <[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
At 07:56 AM 3/17/2004 -0800, Walter Schilling wrote:
>I just got the HW and I have started setting-up a development machine.
>
>The TINI doc insert that came with the HW says 5VDC 300mA and the Getting
>Started web site says to use the 5VDC 150mA  Radio Shack P/N 900-2740.
>Radio Shack doesn't know this P/N.
>
>Would the 5VDC 2.0A that I currently have, damage the TINI board?


If it is 5V 5% then extra current capacity won't hurt.

5V 150 mA is insufficient for m400/s400. 300mA or more is correct.

Regards

Bruce 


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.