CLOSE_WAIT sockets hanging around

Shawn Silverman <[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
Hello.  I'm still seeing the gradual shutting off of my TINI's (m400, 
TStik, '390, firmware 1.12 and 1.02f) because of CLOSE_WAIT sockets 
that are hanging around.  I've made a best effort to close all sockets 
appropriately (in finally clauses, etc.), and I'm not sure what else to 
do.

If sockets, for whatever reason, don't get closed properly, is there a 
timer or something to remove sockets that have the CLOSE_WAIT state so 
that they don't hang around indefinitely?

Thanks,
	-Shawn

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.