Re: TiniHttpServer and GPRS or Tynamo?

Hello Shawn,

Thanks for the fast response.

I think you are correct, but I didn't have time to investigate the issue
properly yesterday.  Oh, the joy of deadlines.

While trying to build, I get a Build Successful message, but I also get
"Could not find BuildDependency. Make sure you have it in your classpath."

Obviously the .tini file isn't created.  I am using the standard
build.properties file.

Thanks,

Simon

----- Original Message ----- 
From: "Shawn Silverman" <[email protected]>
To: "Simon" <simon.ryley-nI4mw7d/[email protected]>
Sent: Tuesday, March 30, 2004 9:56 PM
Subject: Re: [TINI]TiniHttpServer and GPRS or Tynamo?


> Hello, Simon.  Feel free to email me to discuss any questions you have
> regarding building Tynamo for your system.  Most likely it's something
> simple that can be fixed in a few minutes.  If you'd prefer to chat on
> the phone, let me know.
>
> Regards,
> -Shawn
>
> On 30-Mar-04, at 9:15 AM, Simon wrote:
>
> > This is my first post, so hello to all.
> >
> > I need some assistance debugging a TINI problem.
> >
> > I have a Tini 400, firmware 1.12.
> > This is connected to a GSM/GPRS modem via serial4.
> >
> > Thus far, I have a ppp client program written and tested, that will
> > connect
> > to the internet over both GSM and GPRS, and will host a basic web page
> > based
> > on TINIWebServer.  (I should mention that I have static IP GPRS)
> >
> > The problem comes with TiniHttpServer.  When connected over ethernet
> > or GSM,
> > TiniHttpServer works just fine.  It just won't work over GPRS.  The
> > remote
> > web browser sends the request to the Tini, which sees the request and
> > goes
> > into state . It then gets stuck and the TiniHttpServer won't send the
> > web
> > page up the serial link to the web. (I know because I am monitoring the
> > serial between the TINI and the modem)
> >
> > Anyone seen this before?
> >
> > I've checked the TiniHttpServer properties and it is using port 80.
> >
> > I've also followed all the tips in the archives about GPRS.  My ppp
> > connection is the default, and my ethernet subnet is 255.255.255.255
> >
> > Has anyone managed to get a web server to run properly over GPRS?
> > Should I
> > be using Tynamo instead?  (I have tried Tynamo, but could not get it to
> > build correctly for my firmware)
> >
> > As ever, I'm on a tight deadline with this, so would appreciate some
> > help
> > from anyone out there.
> >
> > TIA,
> >
> > Simon
> >
> > _______________________________________________
> > TINI mailing list
> > TINI-6tN4nzCoH/[email protected]
> > To UNSUBSCRIBE, edit your profile, or see list archives:
> > http://lists.dalsemi.com/mailman/listinfo/tini
>

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini