Re: TINIConvertor and ds400 -l option
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
jonathan dumaresq wrote: > hi all, I just try the tinim400 module. I can make a ppp to run in slush. i > try to make this app to run without slush. SO i red in the doc i should put > the -l option when I call the tiniconvertor utility. For the 390 it sould > load in bank 7 and for the ds400 on bank 47. When I load the tbin image, it > is loaded in the bank 7 (i have ds400 board). so i wonder if it have a new > parameters to make this toll working corectly with the ds400 board. Short answer: Add -t 470100 to the command line to relocate the base address. More information (Modifying and Rebuilding Slush): http://www.maxim-ic.com/appnotes.cfm/appnote_number/3108/ln/en -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini