Re: Possibility of Implementing an WLAN Interface on TINI
Manuel Borchers <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Hi! Am So, den 11.04.2004 schrieb Vic um 12:46: > would be is to make use of the existing wired Ethernet > port and use a WLAN bridge (is this the right term?) I would also go this way, much easier and Access Points aren't that cheap anymore. For term-clarification: a WLAN Bridge is when two Access Points build a "bridge" between two separated network-parts, so they don't respond to normal WLAN traffic, they just keep this link up. What you mean has no special naming. You just have to configure the Access Point to work in "Client Mode", so he doesn't behave as an Access Point but as a normal WLAN client as if it was a normal WLAN card in a PC (or whatever other hardware). Cheers, Manuel -- [email protected] http://www.matronix.de - http://www.elektronik-kompendium.de/public/borchers 18:09:49 up 2 days, 17:36, 1 user, load average: 3.46, 3.90, 3.27 _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini