Re: TINI replies with TCP window size set to 0

Robert Muchsel <robert.muchsel-6tN4nzCoH/[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
> Has anyone had a problem where in response to a TCP
> request TINI has replied with a window size of 0? I am
> using "Analyzer" (an Ethernet packet sniffer) I can
> see the TINI receives the message and sends a reply,
> but sets the window size to 0.

This happens when the TINI's input buffers (rather small compared to a
PC) are full. You need to read from the socket (on the TINI), then the
window size will increase.


-- 
  Robert Muchsel - Dallas Semiconductor - http://www.maxim-ic.com/TINI/

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.