Re: TINI replies with TCP window size set to 0
Mark Underwood <basicmark-/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Thanks for the reply. After some investigation I found that the problem was that my XDATA variables where over writing the interrupt vector table. I reserved the first 1K of memory 0x0 - 0x3FF in the startup400.a51 file and it worked fine. Cheers, Mark --- Robert Muchsel <robert.muchsel-6tN4nzCoH/[email protected]> wrote: > > Has anyone had a problem where in response to a > TCP > > request TINI has replied with a window size of 0? > I am > > using "Analyzer" (an Ethernet packet sniffer) I > can > > see the TINI receives the message and sends a > reply, > > but sets the window size to 0. > > This happens when the TINI's input buffers (rather > small compared to a > PC) are full. You need to read from the socket (on > the TINI), then the > window size will increase. > > > -- > Robert Muchsel - Dallas Semiconductor - > http://www.maxim-ic.com/TINI/ > ____________________________________________________________ Yahoo! Messenger - Communicate instantly..."Ping" your friends today! Download Messenger Now http://uk.messenger.yahoo.com/download/index.html _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini