Re: Error in Multibank Load
"Kris Ardis" <Kristopher.Ardis-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <00f101c4296c$43f89d70$764000b4@kardis> |
> When we load the hex file as hex file only, the file is getting loaded. > However, at the end of the file it again gives the error for loading the > file. (for the multibank file.) If we try this on a smaller file, > everything works fine. > > Can you suggest me something, so that I can load multibank hex files? And > still make them work? > I'm a little confused...does the file seem to be loading OK, even though you are getting that error message? If so, it sounds like JavaKit might be trying to do a reset, in which case the error is meaningless for you. Can you run your application or verify the CRC to see if it loaded OK? Kris _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini