Re: serial1 and serail4 flow control
Bruce Boyes <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Quoting Koen Swinters <[email protected]>: > Does someone know on wich pins (port) of the DS80C400 Serial1 and > Serial4 > CTS/RTS signals are located for hardware flow control? You get one set of hardware handshake signals and they can be assigned to either serial1 or serial4. You can check the Dallas online schematics or the ones for TStik serial4 at www.tstik.com, or specifically this page: http://www.systronix.com/tinistik/documentation.html and this page for the schematics of both TStik and the TILT400 socket boards: http://www.systronix.com/tinistik/schematics.html Regards Bruce _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini