Re: External Interrupts and CAN Questions on the DSTINIs400
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Louai Al-Awami wrote: > Thanks for your reply Kelly, > > So do I understand that the tini java 1.12 does not work will with external > interrupts for the TINIs400 evaluation board? Yes, the external interrupts work in TINIOS 1.12. > The pin I use to trigger the interrupt is labeled J4 and labeled as nExtInt. > What is that pin for? For the schematics its INT0. Yes, nExtInt is connected to /INT0. > Another question is I saw in the schematics that all interrupts are on > Port1, but only bin P1.0 and P1.1 and 5.4 to 5.7 are seen on the socket, so > who can I get to the other pins. The P1.4-P1.7 interrupt pins are also used for serial flow control. If you do not need serial flow control, you can rewire these to your interrupt sources. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini