Re: TiniTerm problems

Brian Markey wrote:

>I am having trouble running TiniTerm and suspect a combination of
>problems.  I have TINI s400 sockets board version B and m400
>verification module.  My s400 schematic shows shows lines labeled as
>serial4 going to the RS232 line driver/receiver IC.  These lines map
>back to P6.6 and P6.7 for RXD and TXD respectively, which are serial2 on
>the m400 board.  
>
> 
>
>I've tried running TiniTerm with serial0, serial2 and serial4 and none
>work.  Serial0 seems unresponsive, serial2 throws NoSuchPort exception
>and serial4 is not responsive.  I've tried most combinations of  null
>modem and thru cables but probably not all.
>
> 
>
>Any suggestions?
>  
>
I think you are confusing serial port names. Serial ports 0, 1 and 2 on 
the DS400 chip map to the device names "serial0" , "serial1" and 
"serial4" on TINIOS. The device names "serial2" and "serial3" are 
reserved on TINI for external (off chip) serial ports. This at least 
explains your serial2 issue (since "serial2" does not exist). I cannot 
help with any specifics related to TiniTerm.

> 
>
>Also I do not know what is meant by running my program from ftp prompt.
>When in a dos shell on my host computer and connected to my TINI board I
>can only issue ftp commands.  Java TiniTerm.tini results in an error.
>
>
>  
>


-- 
Thomas Chenot

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini