RE: 1-wire dead?

Dear Brad - Your TINI's "adapter" may have hung on the serail1 as RS232,
rather than 1-Wire.

Remove power and try restarting after you re-apply the power...

I saw this once before, and could not duplicate what led up to it... 8-/

There have been quite a few bug fixes since 1.02d... You should upgrade
anyway.

If that does not work, reload the TINI RTE (1.02g and 1.12 are the latest!),
and repeat at the top with power-off\on.

Good Luck! - Kelly Smith

-----Original Message-----
From: Brad Zdanivsky [mailto:[email protected]]
Sent: Sunday, June 06, 2004 4:41 PM
To: tini-6tN4nzCoH/[email protected]
Cc: Kelly Smith
Subject: 1-wire dead?


I just had ro re-load tini.tbin and slush.tbin

now my 1-wire apps puke:

Exception: com.dalsemi.onewire.OneWireException: Port found "serial1" but
Adapter "TINIExternalAdapter" not det
ected
com.dalsemi.onewire.OneWireException: Port found "serial1" but Adapter
"TINIExternalAdapter" not detected
No other stack trace info available.

any ideas why?

it's firm 1.02d, same as what was loaded before when things were all good.

thnxs,

Respectfully,

=====================================================
Brad Zdanivsky
http://VerticalChallenge.org
http://cordclimbs.ca
http://www.cywil.com/
=====================================================


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini