External Interrupt 4

"Liapis Dimitris" <liad-S/[email protected]> Tue, 8 Jun 2004 13:20:06 +0300

Newsgroups	gmane.comp.hardware.microcontrollers.tini
Message-ID	<011301c44d42$2bb46740$1f2c7c92@pcnt31>

    Hello,

I am using a TINIm400 board (with TINIS400) and the 1.12 firmware.
I need to use the external interrupts 2 and 4. External interrupt 2 works
just fine, but I don't get any interrupts from external interrupt 4.
I tried to give a software interrupt for external interrupt 4 and I get it
normally.
I also tried to define the pin P1.6 as an input before using it as an
interrupt pin (setting it to "one"), but it did not work.
Is there any problem with external interrupt 4?

Thanks.

Regards, Dimitris

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini