RE: TINI Reboot Problem
"Bill Smith" <[email protected]> Fri, 11 Jun 2004 08:04:55 -0400
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
U1 is in place. I'll check the power supply. What I'm using is a RadioShack 12v 1000mA wall wart. One thing I did try, and this was based on someone having a problem with similar symptoms in the archives. I switched from being a dhcp client to a static ip and it has been running for 23 hours now. Back when I was at 1.02b, I was running with a static ip. The other thing I did was remove the dtr reset enable jumper. -----Original Message----- From: Bryan Armstrong [mailto:bryan.armstrong-6tN4nzCoH/[email protected]] Sent: Friday, June 11, 2004 7:51 AM To: Bill Smith Cc: tini-6tN4nzCoH/[email protected] Subject: Re: [TINI]TINI Reboot Problem Bill Smith wrote: > Sometimes it will go for hours, other times just for 30 minutes or so. > It this point in time, I have nothing other that the os installed and > have the network set up as a dhcp client. Verify your power supply. If your socket board has U1 placed, it can handle AC or DC from 8 to 20V. If U1 is not placed, the board requires a 5V+-5% regulated supply. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini