RE: General TINI Questions

Thanks Bryan,

But I wished if I had some answers in numbers rather than descriptions.

The emulator I meant of course need to test TINI specific applications, I
guess there still no such TINI specific one.

Thanks again.

-----Original Message-----
From: Bryan Armstrong [mailto:bryan.armstrong-6tN4nzCoH/[email protected]] 
Sent: 14/Jun/2004 5:42 AM
To: Louai Al-Awami
Cc: tini-6tN4nzCoH/[email protected]
Subject: Re: [TINI]General TINI Questions

Louai Al-Awami wrote:
> 1. What is the maximum frequency that TINI can generate using java without
> observing an overhead? 

Java always has overhead.  The amount of overhead depends on what the 
application is doing between calls to change the port pin.

> 2. The Blinky program attached with the TINI1.12 SDK uses Thread.sleep()
> method to generate the required delay, but using this scheme that maximum
> frequency that can be generated is 50Hz (using sleep() with 1ms), is there
> another way to generate higher frequency? Any resources about JNI with
TINI
> assembly?

Yes, see <tinidir>/docs/Native_Methods.txt, and the native library 
example in the TINI SDK.


> 3. The only way to upload a file to TINI is through FTP, which is a time
> consuming operation. Is there another way of doing that? 

I get about 29Kbytes/second on a moderately loaded network.  Is it 
possible some local network issue on your end is hindering program load?

> 4. Is there any TINI emulator by which you can test your programs before
> running them on TINI?

One good way to test an application is to run it on your PC.  You can 
test all application code that does not use specific hardware only 
available on TINI.

-- 
--
Bryan Armstrong
bryan.armstrong-6tN4nzCoH/[email protected]


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini