Re: 24 Volt 1-Wire dry contact relay??
Bruce Boyes <[email protected]> Wed, 23 Jun 2004 10:58:58 -0600
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
At 06:52 PM 6/22/2004 -0400, Joel Rowley wrote: >Hey List, > >I am looking for a 24 Volt 1-Wire dry contact relay. What I mean by this is >that the relay can handle 24 volts going through it, not that the relay is >powered by 24 volts. Do any of you know if there is something like that out >there or not? You can purchase these at DigiKey and connect them to an 8x1 Wire board as long as the relay coil can be powered by 12 volts or less at 50 mA or less so that it can be driven by PIOA from a DS2406.: http://www.systronix.com/expansion/8x1wire/81w.htm and http://www.systronix.com/expansion/8x1wire/DS2406_relay_drive.pdf Regards Bruce >Thanks! >Joel Rowley > >_______________________________________________ >TINI mailing list >TINI-6tN4nzCoH/[email protected] >To UNSUBSCRIBE, edit your profile, or see list archives: >http://lists.dalsemi.com/mailman/listinfo/tini _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini