Re: Compiling dBUG with GCC

Hi Matt,

thanks for your reply. This was a very useful information. I was  
wondering why dBUG is not shipped with the BSP for M548xEVB but good  
to know that I can get the (GCC compilable) source from the other BSP's.

Thanks again and regards,
Markus

Zitat von Matt Waddel <[email protected]>:

> Hi Markus,
>
> Currently there are 4 Coldfire platforms that have gcc/dBUG build
> capabilities; m5208evb, m5253evb, m5329evb, and m5373evb.  The
> source can be found in any of the LTIB BSPs for those platforms.
>
> http://www.freescale.com/webapp/sps/site/overview.jsp?code=CW_BSP&srch
>
> If you install and run ./ltib -c then select build a bootloader, dBUG
> you should see a gcc build.
>
> I found that most of the gcc build information can be derived from the
> other build systems.
>
> Good luck,
> Matt
>
> Markus Franke wrote:
>> Dear Coldfire Users,
>>
>> this is probably a common asked question. Unfortunately I didn't   
>> find any answers on the web, so far. Is there anybody who has   
>> experiences with compiling dBUG with the GNU Compiler Collection? I  
>>  would love to get hands on some Makefiles. Which parts of the dBUG  
>>  source tree have to be adapted to the new toolchain? I guess there  
>>  should be added new folders under <DBUG>/build and   
>> <DBUG>/proj/<PROJECT>/build for the GCC toolchain, right?
>>
>> Thanks in advance and regards,
>> Markus
>>
>>
>> ---
>> [email protected]              Send a post to the list.
>> [email protected]        Join the list.
>> [email protected]    Join the list in digest mode.
>> [email protected]     Leave the list.
>>
>>
> ---
> [email protected]              Send a post to the list.
> [email protected]        Join the list.
> [email protected]    Join the list in digest mode.
> [email protected]     Leave the list.




---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.