Fw: The MCF52211EVB ISSUE

Dear all

This is extension to earlier mail. The board starts up with the precompliled 
.s19 mass storage file. Shows the Mass storage driver started. Then if types 
Dir content obce afterwords it doesnot show responec to any command.

The yesterday's problem still exists

regards
Sanjay Morab

----- Original Message ----- 
From: "Sanjay Morab" <[email protected]>
To: <[email protected]>
Sent: Thursday, January 10, 2008 4:35 PM
Subject: The MCF52211EVB ISSUE


>
> I had purchased the MCF52211EVB for the USB HOST developement. I had 
> installed CMX CD. The problem is all docuemnts status using MCF52223 
> Micrcontroller , even the sample code also uses the same. I had tried to 
> use CMX samples and downloaded to EVB its gets downloaded but it does not 
> work. I had tried the HID and mass Storage demo. When I start dugging I 
> get the message
> "Exception Vector Error: Address Error". I couldnot find any reason for 
> this.
>
> Buf when I build test program IO reading / Wring UART etc with my 
> application the files downloads the works problem.
>
> I need to urgently test USB mass Storage as my one project I want to 
> interface USB PEN DRIVE AND USB HDD.
>
> Please let me know what may be the cause.
>
>
> Sanjay Morab 

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.