Re: no activity on MCF5275 QSPI bus

"David van Geest" <[email protected]> Thu, 13 Mar 2008 16:26:12 -0400

Newsgroups	gmane.comp.hardware.motorola.microcontrollers.coldfire
Message-ID	<[email protected]>

Marc and Richard,

On Thu, Mar 13, 2008 at 3:21 PM, Marc Vincent <[email protected]> wrote:
> Have you setup the QSPI PAR register properly? Default function is
>  GPIO (ie. pulled-up input) for all pins. Hope this helps.
>  Marc

You are both correct.  For some reason I was assuming that the pins
were set to QSPI, not GPIO, by default.  My app works the way it
should, my driver is almost ready, and I'm feeling somewhat
sheepish.... :-)

Thanks!
-David
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.