Adding a UART to 52277EVB

Hey there,
I apologize in advance...I am new to Linux and the Coldfire MCF52277.
The 52277EVB has an application using NanoX and uCLinux.  I was able to
get a tool chain up and running and can compile the sample app and run
it on the board and everything works fine.  The terminal output from
Linux comes across on UART0.  I want to use UART1 for an add on board,
but when I set up UART1 in my application and try to get a character or
send one it freezes the application.  The Linux console is still active
though. The functions used to send data across UART1 work if I compile
in CodeWarrior and just download it via the debugger.  

Any ideas on what I need to do to get the data to UART1?

Thanks,
Craig
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.