Re: Finding Hardware Interrupt Number

Not familiar with uCLinux' mapping, but I would imagine it aligns its
vectors to the hardware's. EPF5 is source 5 for interrupt controller
0, so the hardware vector is 0x45. Hope this helps.

On Mon, Jun 9, 2008 at 11:22 AM, Fahd Abidi <[email protected]> wrote:
> I am wondering if some one can point me in the right direction. We have a
> platform where we are using Interrupt Pin 5 on our coldfire MCF5275, we are
> running a UCLinux kernel 2.4 and I am trying to figure out which IRQ number
> in the kernel maps to Hardware Interrupt 5? Is there an easy way to figure
> this out?
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.