Re: gdb on M54455EVB Linux

Kurt Mahan <[email protected]> Thu, 26 Jun 2008 10:26:16 -0600

Newsgroups	gmane.comp.hardware.motorola.microcontrollers.coldfire
Message-ID	<[email protected]>

Hi Jim,

Could you describe the setup you are using? I'll look into this but I'd
like to make sure I'm following the same steps as you.

--Kurt

Douglas, Jim (Jim) wrote:
>
> Has anyone had any success running gdb using the Freescale Linux BSP
> for the M54455EVB eval board?
>
> I just get ‘illegal instruction’ when I try to run anything inside the
> debugger.
>
> --jim douglas
>
> [email protected] Send a post to the list.
> [email protected] Join the list. [email protected]
> Join the list in digest mode. [email protected] Leave the list. 

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.