RE: PROGCFZ M54455EVB

There was an update to CF Flasher from 3.1.9 to 3.1.10 that fixed a
flash programming issue.
You can grab it from the Freescale website:
http://www.freescale.com/files/soft_dev_tools/software/programmers/CFFLA
SHER.zip?fsrch=1 
But for P&E PROGFCZ you should registger on their website
(www.pemicro.com) and ask this question or look for updated config file
support.
Hope this helps...if not yell back.
Regards, 
David 
 
David E Seymour

http://www.freescale.com/coldfire

 

________________________________

From: [email protected] [mailto:[email protected]]
On Behalf Of Granville Gregg
Sent: Tuesday, October 07, 2008 4:58 PM
To: Seymour David-RA2693
Subject: [ColdFire] PROGCFZ M54455EVB



Need to know which file (CFG) to use to program through P&E For the
M54455EVB The board has a AT49BV040 on it as the U-Boot I am trying to
program my board through the BDM using PROGCFZ from P&E Micro in the
past there has been either a .cfg file relating to the evm board like
M5329EVB.cfg or the other way was through the P&E files they do not have
one that small in that type.

 

Regards Gregg

________________________________

Gregg GRANVILLE

Hardware Engineering Manager

-------------------------------------------------------

Tel 1 603.622.0212 / Fax 1 603.623.5623

[email protected] <mailto:[email protected]>  /
www.metronics.com <http://www.metronics.com> 

------------------------------------------------------------------------
-----------------

METRONICS /// 30 Harvey Road // Bedford, NH 03110-6818 / US

 

[email protected] Send a post to the list.
[email protected] Join the list. [email protected]
Join the list in digest mode. [email protected] Leave the
list.