RE: Trying to bring up a MCF54450VM240

Hi Kurt

No luck finding it, I did a search on downloads and it is not under the pag=
e for the 54455. It would be a great help to me if you can find it Happy Tu=
rkey day

Gregg

-----Original Message-----
From: [email protected] [mailto:[email protected]] On=
 Behalf Of Kurt Mahan
Sent: Tuesday, November 25, 2008 4:50 PM
To: Granville Gregg
Subject: Re: [ColdFire] Trying to bring up a MCF54450VM240

Hi Gregg,

There is a version of dBug that should work.  I used it when I was
debugging the original 54455 design.

You might check the freescale dbug downloads (I'm not sure where it
is).  If you can't find it let me know and I'll ask around (though it is
thanksgiving week).

--Kurt

Granville Gregg wrote:
> Hi all=20
> Trying to bring up a MCF54450VM240 design currently I am using U-boot-1.2=
.0. Does anyone have a smaller piece of code that might be easier my design=
 is using a 16 bit data buss with a PC28F256P33B85 I am using the same DDR =
ram as is used on the reference design MT47H64M8CF-3:F but only two chips i=
nstead of 4. Usually when breathing life into one of these I like to use a =
smaller code base but unfortunately the only thing offered by Freescale is =
U-Boot under Linux
>
> Thanks Gregg Granville
>
> ---
> [email protected]              Send a post to the list.
> [email protected]        Join the list.
> [email protected]    Join the list in digest mode.
> [email protected]     Leave the list.
>
>  =20

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.