Can a 3.3v input handle 5v?

Bob Furber <[email protected]> Wed, 11 Mar 2009 14:26:23 -0700

Newsgroups	gmane.comp.hardware.motorola.microcontrollers.coldfire
Organization	Intec Automation Inc.
Message-ID	<[email protected]>

I am having difficulty finding out if a 3.3v input can handle 5v on a 
MCF5282 DMA Timer pin used as an input?

Would there be clipping diodes? If so, then one would need some 
protection resistors to limit current input?

Thanks,

Bob Furber


---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.