Question about FlexCAN module and uClinux-dist-20080808

/* Sorry for my poor English */

Hi,

I test uClinux on Freescale Coldfire MCF5329. I work with the =93Zoom
Coldfire SDK Development Kit=94. For my first task, I design a
CAN-Ethernet bridge. For this, I follow step-by-step the application
note =93AN3408 =96 Building a Sample CGI Application=94 from Freescale. For
the moment, I search a build a correct uClinux image (with CAN driver
!). A lot of points are OK (I build an uClinux image, I send and run
it with dBug program, ...). But, in the uClinux kernel configuration
menu, I don't find the =93ColdFire FlexCAN module support=94 option (To
have CAN4Linux drivers for the FlexCAN module on MCF5329 - page 10 of
the application note). This is the only option (of the application
note, pages 6=3D>12) that I can not find.

Anyone knows its location ?

I work with the latest uClinux-dist (20080808), but I have the same
problem with all previous distribution of uClinux (20070130, 20060803,
20051110).

Thanks.

Val
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.