BDM Tools via USB

Hello,

I have a board that does a USB->BDM interface, and have been trying to
configure BDM tools to recognize a coldfire V2 (MCF52258) on a PCB. It used
to work on Windows, but I've been trying to do it on Linux, and even bdm-chk
fails. 

Whenever I plug it in, a new usbdev device is created, but I still can't do
a open /dev/usbdevX.X_ep00 on it.
What are the steps I should take to have it running? 

Thanks for any replies.

PS: I thought of posting this on BDM tools forum, but apparentely they
haven't answered a single question in quite a few months, so I take it the
developers don't follow that forum too much, this seemed like a more active
place.
-- 
View this message in context: http://old.nabble.com/BDM-Tools-via-USB-tp27499031p27499031.html
Sent from the Coldfire mailing list archive at Nabble.com.

---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.