Re: Looking for usable toolchain to build 2.6 or 2.4 kernel for M5407C3 board

Hi Alex,

Alex Perez wrote:
> I'm looking for a usable toolchain to build a kernel for this old board. Also, if anyone happens to have, lying around, a binary kernel built for the M5407C3 which I could flash for testing, I'd be greatly appreciative. 

I used to keep binaries for common boards up at uclinux.org.
Although I haven't used them, or referenced them, in a while it
looks like they are still there:

   http://www.uclinux.org/ports/coldfire/binary.html

There is one for the M5407C3, give it a go :-)

There is also a collection of toolchains (that I use to build the
uClinux-dist) on uclinux.org:

   http://www.uclinux.org/pub/uClinux/m68k-elf-tools/

My M5407C3 board no longer works, so I can't actively test each
release. But there is a good chance that current uClinux-dist
support for the M5407C3 still works. (I build test 2.4.x and 2.6.x
kernels for most ColdFire boards every uClinux-dist release).

Regards
Greg


------------------------------------------------------------------------
Greg Ungerer  --  Principal Engineer        EMAIL:     [email protected]
SnapGear Group, McAfee                      PHONE:       +61 7 3435 2888
8 Gardner Close                             FAX:         +61 7 3217 5323
Milton, QLD, 4064, Australia                WEB: http://www.SnapGear.com
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.