RE: PWM in MCF52259

X-SpamDetect-Info: ------------- Start ASpam results ---------------
X-SpamDetect-Info: This message may be spam. This message BODY has been altered to show you the spam information 
X-SpamDetect: *****: 5.1 sd=3d5.1  [95]02%-11.7(Accept Orbs) [218]97%11.5(!46,66) [43]03%-11.0(X-SpamContent:clean) [45]94%9.1(X-Verify-Helo:-ERR) [69]92%8.0(From: ends in number) [61]70%0.9(X-myrbl:Color=3dblue) [27]47%-0.0(X-LangGuess:English)
X-SpamDetect-Info: ------------- End ASpam results -----------------

Hi Sanjay,
I think it best to use the Freescale MQX forums sight for help with MQX
and PWM.
http://forums.freescale.com/t5/Freescale-MQX-trade-Software/bd-p/MQXGEN=20
I've done minimal PWM work such as verifying I can make the PWM change
duty cycle from 0-100%.
So nothing complicated.
Regards,
David=20

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Sanjay Morab
Sent: Thursday, October 14, 2010 6:51 AM
To: Seymour David-RA2693
Subject: [ColdFire] PWM in MCF52259

Dear all

Does any one had worked using PWM in MQX RTOS;

If yes pl guide me

regards
Sanjay Morab
---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.



---
[email protected]              Send a post to the list.
[email protected]        Join the list.
[email protected]    Join the list in digest mode.
[email protected]     Leave the list.