Program variable on the internal flash of MPC566 on runtime
"crbtfp" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Hi
I have axiom 566EVM. I use Code Warrior 8.0. I do the sampling of
analog signal by QADC64E. Because SRAM is too small.I want to save
this result in internal flash memory on runtime. Can I do that?
I 've tried to program to flash on runtime by save the output result
of QADC64E to a variable in SRAM then I want to program that
variable to internal flash on runtime. The mpc566 ref. manual is
unclear, how to write to address data latch and how to program to
program data latch of MPC566. I can not make EHV bit go high(=1)
Does anyone have recommendations?
And Does anyone know how many times can I program to the internal
flash memory? one manual said 1000 times another manual said 100000
times
Thank you very much
PS
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/