Re: Re: how to config the matlab to develop the mpc566

Hi Jon,
Thank you very much. Now I can download the codes into the internal flash. I used the board developed myself. It has no external sram or flash. But I found I couldn't boot the code when I reset the board without BDM  cable. Does the bootcode and the code generated by matlab can execute in normal mode(I mean it isn't in debug mode.)
Thanks.
                   Ning
mworksjjf <[email protected]> wrote:

Hi Ning,

The Embedded Target for Motorola MPC555 supports the following memory 
models:

i) External RAM (text & data) + internal RAM (stack)
ii) Internal flash (text) + internal RAM (data, stack)
iii) External flash (text) + internal RAM (data, stack): requires
some 
manual configuration!

To target only internal RAM (text, data & stack) would require manual 
modification of the Embedded Target and would not be supported by the 
MathWorks.   You may also find that you would run out of memory
quickly 
depending on the size of your models.

I would recommend that you choose the internal flash memory model
(see 
the "Target memory model" setting in the model's MPC555 Real-Time 
Workshop settings in the Configuration Parameters).

Alternatively, do you have any other evaluation boards available that 
have external RAM?

Also, what eval board are you currently using?

Thanks,

Jon.

--- In [email protected], ning zhao <noiseworld2004@y...> wrote:
> Hi, I use the embedded target for mpc5xx of matlab7.0.1 to develop 
the mpc566. But the matlab uses the default external sram, and my 
mpc566evb has no external sram. I don't know how to config the matlab
> use the internal sram. Who can help ?
> 
> 
> 
> ---------------------------------
> Do You Yahoo!?
> 注册世界一流品质的雅虎免费电邮
> 
> [Non-text portions of this message have been removed]





-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu






---------------------------------
Yahoo! Groups Links

   To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
  
   To unsubscribe from this group, send an email to:
[email protected]
  
   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 




---------------------------------
Do You Yahoo!?
注册世界一流品质的雅虎免费电邮

[Non-text portions of this message have been removed]



-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/