RE: Program variable on the internal flash of MPC566 on runtime

Hi
I want to save total 64Kbyte(SRAM on chip only 36 Kbyte) of data in the 
internal flash. Actually I want to save result from 32 channels 10 
bits/channel from QADC  for every 1 ms for 1 sec to flash memory in runtime

Can I program data to flash in runtime?

Thank you
PS

>From: Dobbin Allan-r11834 <[email protected]>
>Reply-To: [email protected]
>To: "'[email protected]'" <[email protected]>
>Subject: RE: [MPC500] Program variable on the internal flash of MPC566 on 
>runtime
>Date: Thu, 21 Apr 2005 07:37:38 -0700
>
>Are you saying that you want to save the QADC conversion result to FLASH 
>just because the SRAM is too small?  This sounds like quite a lot of work 
>just to save a couple of bytes of SRAM.  If you want to store this result 
>in FLASH so that it is available after reset, that is a valid reason.  But 
>if you want to save it to FLASH just to save a few bytes of SRAM, that 
>sounds unreasonable and you may want to reconsider.
>
>Regards,
>Allan
>
>-----Original Message-----
>From: [email protected] [mailto:[email protected]] On Behalf Of 
>crbtfp
>Sent: Wednesday, April 20, 2005 2:22 PM
>To: [email protected]
>Subject: [MPC500] Program variable on the internal flash of MPC566 on 
>runtime
>
>
>
>
>Hi
>
>I have axiom 566EVM. I use Code Warrior 8.0. I do the sampling of
>analog signal by QADC64E. Because SRAM is too small.I want to save
>this result in internal flash memory on runtime. Can I do that?
>I 've tried to program to flash on runtime by save the output result
>of QADC64E to a variable in SRAM then I want to program that
>variable to internal flash on runtime. The mpc566 ref. manual is
>unclear, how to write to address data latch and how to program to
>program data latch of MPC566. I can not make EHV bit go high(=1)
>Does anyone have recommendations?
>
>And Does anyone know how many times can I program to the internal
>flash memory? one manual said 1000 times another manual said 100000
>times
>
>
>Thank you very much
>PS
>
>
>




-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/