Reg QADC
"vijayanandl" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Hello
I have a question regarding the QADC in MPC565. We were
considering using the processor for a new project. But found that in
other processors (say from Infineon) you can configure the range of
analog input value. So instead of the standard 0-5V it is possible to
configure it as 0-100mv so that there is minimal loss of resolution.
Our application demands programmable ADC ranges that is from 0-100mv, 1-
1.5V etc. Is it possible to configure individual ADC channels to
process at different analog input voltage ranges in the MPC565?
Regards
Vijay
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/