Board requirements for MPC555 single-chip BDM
"murphynetuk" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Hi,
I'm just about to build up my first board with an MPC555. I was
wondering what the minimum board component population would need to be
to test the chip with a BDM connected (P&E).
Obviously I need the power supplies, do I need:
Crystal etc.
Reset supervisor
Pull-ups/downs on any particular lines?
I don't want to solder any components I don't need to before I verify
the MPC555 is OK.
Regards, Ian
------------------------ Yahoo! Groups Sponsor --------------------~-->
Most low income households are not online. Help bridge the digital divide today!
http://us.click.yahoo.com/cd_AJB/QnQLAA/TtwFAA/dN_tlB/TM
--------------------------------------------------------------------~->
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/