RE: 555 BDM startup problem
"Randall Young" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
> Every morning I power up the Abatron BDM pod,
> then the 555 board,
Chuck, this may have absolutely nothing to do with your problem. But ISTR
reading several years ago that it's important to power up the processor
first. Apparently the BDM pod can put enough power into the processor
through the signal lines to confuse it.
Anyway, it's easy enough to try.
Randall Young
Senior Software Engineer
NavCom Technology, Inc.
A John Deere Company
Tedious disclaimer :
"The information contained in or attached to this message, to the extent
it is non-public, is the confidential, proprietary information of NavCom
Technology, Inc., its affiliates and/or subsidiaries (collectively,
"NavCom") and may not be reproduced, disclosed to any third party or used by
recipient and/or the recipient's employer (hereinafter "recipient"), for
other than the intended purpose for which it was provided to the recipient,
or other than in accordance with the terms of any Confidentiality or Non
Disclosure Agreement between NavCom. and the recipient, without the prior
written approval of NavCom. If you are not the intended recipient or the
person responsible for delivering the electronic mail to the intended
recipient, be advised that you have received this electronic mail in error
and that any use, dissemination, forwarding, printing, or copying of this
electronic mail is strictly prohibited. If you have received this
electronic mail in error, please immediately notify the sender by return
mail."
------------------------ Yahoo! Groups Sponsor --------------------~-->
Get Bzzzy! (real tools to help you find a job). Welcome to the Sweet Life.
http://us.click.yahoo.com/A77XvD/vlQLAA/TtwFAA/dN_tlB/TM
--------------------------------------------------------------------~->
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/