PLL not locking

Hi
I'm using MPC566 in my board. The pin configuration of my board is same 
as the evaluation board of MPC566. I'm using 4 Mhz crystal oscillator 
and XFC 0.033 microfarad (same as used in evaluation board). I'm able 
to write internal flash using BDM port, but when i try to run program, 
the SPLSS bit in PLPRCR is not setting. I've checked the CLKOUT signal 
of both evaluation board and my board, the waveform is same. I mean 
noise level is same as the evaluation board. Please suggest something 
what could be the reason.

Thanks and Regards
Pradeep





-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/