FPU Buffer Error
"serenepheonix" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Hello,
I am trying to burn automotive code on a MPC555 Revision M chip and
keep getting a FPU buffer address error. I've tried dozens of
different addresses (that i've seen suggested over a bunch of
different posts and websites), but nothing has worked so far.
Over the past few weeks I've been experimented with changing RAM
and .lcf settings, but still no avail.
The exact same code and settings work great with Revision K3 MPC555
chips. This (obviously) makes me think there is problem with the
chips...
I'm using Metrowerks 8.0, and MSI Wiggler...
I'm really hoping someone can help me...
Any ideas?
I was under the impression that the FPU buffer address was just
scratch space and could be any free RAM...
Thanks for your time,
Mick
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/