Re: makefile generator

Thanks, Randall. It sounds like you're acutally using this. Are you by
any chance using QuickStart, and have you found that you were able to
configure OpusMake to handle all of that?

Joe


--- In [email protected], "Randall Young" <ryoung@...> wrote:
>
> 
> > I'm using Diab 5.1.2 for MPC555 development, with no IDE, and I'm
> > tired of trying to update file dependencies in my makefile. Does
> > anyone know of a makefile generator for "C" that is available for
> > Windows?
> 
> Opus Make comes with one, seems to work pretty good.
> http://www.opussoftware.com/product/product.htm
> 
> Randall Young
> Senior Software Engineer
> NavCom Technology, Inc.
> A John Deere Company
> 
>     "The information contained in or attached to this message, to
the extent
> it is non-public, is the confidential, proprietary information of NavCom
> Technology, Inc., its affiliates
>         and/or subsidiaries (collectively, "NavCom") and may not be
> reproduced, disclosed to any third party or used by recipient and/or the
> recipient's employer (hereinafter
>         "recipient"), for other than the intended purpose for which
it was
> provided to the recipient, or other than in accordance with the
terms of any
> Confidentiality or Non Disclosure
>         Agreement between NavCom. and the recipient, without the prior
> written approval of NavCom. If you are not the intended recipient or the
> person responsible for delivering the
>         electronic mail to the intended recipient, be advised that
you have
> received this electronic mail in error and that any use, dissemination,
> forwarding, printing, or copying of this
>         electronic mail is strictly prohibited.  If you have
received this
> electronic mail in error, please immediately notify the sender by return
> mail."
>







-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/