Re: UART Communication between MPC566 and a 8bit Microcontroller

Hi Rajesh,

The two UARTs must be configured with the same settings to communicate
with each other:

 - baud rate, data bits, parity, stop bits

If you have them set up the same way, and they are not communicating,
you must be doing something else wrong.

Joe

--- In [email protected], "Rajesh" <rajesh86us@...> wrote:
>
> 
>  Hi,
>            I am using two microcontrollers, one is MPC566 with 40 MHz
> clock,and other one is a 8 bit,running at 22.1184 MHz. I am trying for
> (OnBoard) inter-processor UART communication,by running MPC at a
> baudrate of 19200 and the other at 9600. 
> The problem is, sometimes it runs and data Trasmission and Recieving
> is ok, but sometimes it's  not.
> I tried by configuring both with same baud rates but geting same
problem.
> Can anyone please suggest,how to deal with this problem?
> 
> -regards
> Rajesh
>






-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/MPC500/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/