RE: MPC5554 codewarrior features -- newbie question

The MPC5500 flasher utility is freeware which can be downloaded from the
MPC5554 page on the Freescale site.  It can program s-record files into
flash which have been generated by CW.
 
- Allan

________________________________

From: [email protected] [mailto:[email protected]] On Behalf
Of Dees Randy-rsaf30
Sent: Monday, January 08, 2007 9:59 AM
To: [email protected]
Subject: RE: [MPC500] MPC5554 codewarrior features -- newbie question



Codewarrior has the capability of generating code that can be programmed
into the flash and boot the device. It does not have flash programming
software built into it. The Lauterbach debugger fully supports
programming the internal flash of the MPC5500 devices.

randy 

________________________________

From: [email protected] <mailto:MPC500%40yahoogroups.com>
[mailto:[email protected] <mailto:MPC500%40yahoogroups.com> ] On
Behalf
Of sydny_faria
Sent: Monday, January 08, 2007 9:46 AM
To: [email protected] <mailto:MPC500%40yahoogroups.com> 
Subject: [MPC500] MPC5554 codewarrior features -- newbie question

we have the CW build only version for the MPC5554 cost $4800 approx. 
Does this version enable me to set up a project to write the code to 
flash easily? We also have the Lauterbach ICD which seems to have the 
necessary ability to do this but I am under severe time constraints and 
would rather have the CW do this if it is part of its functionality. 
Would the more advanced version of CW for the MPC5554 have been a 
better choice ? 

.

<http://geo.yahoo.com/serv?s=97359714/grpId=6276387/grpspId=1706554205/m
<http://geo.yahoo.com/serv?s=97359714/grpId=6276387/grpspId=1706554205/m
> 
sgId=3795/stime=1168271601/nc1=3848601/nc2=3848525/nc3=4025377> 


[Non-text portions of this message have been removed]



 


[Non-text portions of this message have been removed]