RE: mpc555 internal flash programming

how do i program the CMFCFIG word location with 0x0?

Dobbin Allan-r11834 <[email protected]> wrote:          You may write to IMMR[FLEN] (SPR 638) bit using the debugger to enable
flash. If you want flash enabled from reset, yoy have to program the
CMFCFIG word at location 0x00 in shadow flash.

- Allan

________________________________

From: [email protected] [mailto:[email protected]] On Behalf
Of Prathamesh
Sent: Monday, September 24, 2007 11:13 AM
To: [email protected]
Subject: [MPC500] mpc555 internal flash programming

Hi,
I am working with mpc555 with Greenhills C compiler. On my board i 
have pulled /RSTCONF to high, i.e hard reset configuration word is 
being read as default 0x00000000. 
I need to write into internal flash of mpc555. For that bit 20 of hard 
reset configuration word should be 1 ie. FLEN should be set.

How can i achieve this with this configuration?

Or the only option in this case is making /RSTCONF as low and read the 
hard reset configuration word from the data lines. Here i will need to 
pull down all the data lines except D20 which i will need to pull up.

[Non-text portions of this message have been removed]



                         

       
---------------------------------
Need a vacation? Get great deals to amazing places on Yahoo! Travel. 

[Non-text portions of this message have been removed]