RE: external SRAM interface with MPC555

ISSI (http://www.issi.com) makes some SRAMs that are automotive
temperature grade.
 
See the MPC5xx evaluation board schematics (http://www.axman.com) how to
connect SRAM devices.
 
the internal flash on the MPC555 is optimized to give performance almost
as good as external fast SRAM.
 
SDRAMs usually require some interface logic. Most customers use SRAM or
external flash.

________________________________

From: [email protected] [mailto:[email protected]] On Behalf
Of Sushmitha
Sent: Tuesday, October 09, 2007 1:08 AM
To: [email protected]
Subject: [MPC500] external SRAM interface with MPC555



Hello,

SRAM is required to be used with an MPC555, in an Avionics 
application (-55C to 125C ambient temperature).

Program code will be downloaded from Flash memory(internal flash of 
MPC555) to the SRAM. SRAM must be fast enough for the MPC555 to run 
code at the full 40MHz speed?

The minimum total amount of SRAM that is required is 256Kbytes, up 
to 2Mbytes if possible. it can be x32 configuration or x16 
configuration, 

The usage of internal flash of the microcontroller and external 
SRAM interfaced to microcontroller MPC555 can be done?

Is it possible to interface SDRAM to MPC555.If yes how the control 
signals will be interfaced?

Thanks,
Sushmitha


.
 
<http://geo.yahoo.com/serv?s=97359714/grpId=6276387/grpspId=1706554205/m
sgId=3907/stime=1191910121/nc1=3848627/nc2=4507179/nc3=4025321> 
 


[Non-text portions of this message have been removed]