phyCORE-MPC565 FREE SOFTWARE

"dariusz.piechota" <[email protected]> Sat, 22 Dec 2007 13:14:52 -0000

Newsgroups	gmane.comp.hardware.motorola.microcontrollers
Message-ID	<[email protected]>

Hi,
I have phyCORE-MPC565 board. I am totally fresh about using this
board. I want to do some programming on it using FREE software. The
only one I&#8217;ve found is http://www.macraigor.com/full_gnu.htm I am
after installation of this software. What is the next step to program
this device? Do I need special hardware interface to program it?

Thanks,
Dariusz Piechota
Poland