Re: Is there a best practice for adjust RAID "scrub" options?
Sylvain Robitaille <[email protected]>
| Newsgroups | gmane.comp.hardware.netapp |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 30 May 2019, tmac wrote: > This is normal. I forget the options at this point (dont really use > them any more) but there is a default limit as to how long scrubs > will run. They remember where they left off and pick up one week > later. Right. I understand all that. I was really hoping more for pointers to documentation that would help me decide wether or not to make any adjustments, and what to adjust _to_. The default, at least for the version of Ontap we're using is described in my original message (as well as, come to think of it, which options are relevant ...). > It also, if I recall correctly will only do so many scrubs at the same > time. I haven't found any documentation to that effect (though, of course it makes sense, and I do expect that's the case). Do you have any you can point me to? > Remember, it is not just scrubbing the aggregate, but looking at each > Raid Group for consistency. Yes, I understand that. -- ---------------------------------------------------------------------- Sylvain Robitaille [email protected] Systems analyst / AITS Concordia University Faculty of Engineering and Computer Science Montreal, Quebec, Canada ---------------------------------------------------------------------- _______________________________________________ Toasters mailing list [email protected] http://www.teaparty.net/mailman/listinfo/toasters