Re: small query reg upgrade from 9.4p1 to 9.5p6 C-Mode

Raj -

My usual practice is to obtain the image from an http/https server.   Download something like xammp (Apache LAMP stack) and install it on your laptop/desktop then drop the ONTAP package into the docroot for the built in web server, start the http/https service and use the “-get” with http{s}://<your_ip>/<ONTAP_version.tgz

This method makes it really easy to upload new disk qual files, firmware, etc. as well.

Best of luck to you!

Anthony Bar
650.207.5368<tel:650.207.5368>
[email protected]<mailto:[email protected]>
www.berkcom.com<http://www.berkcom.com/>

On Jul 25, 2019, at 3:32 AM, Yuvaraja Shivaram <[email protected]<mailto:[email protected]>> wrote:

Hi all,

I have uploaded 9.5p6 software to the path /mroot/etc/software/ ... Manually(using system shell), in both the nodes

so now would like to validate the version with below command...

cluster image validate -version 9.5p6
it is getting failed since package is not there in the system repository...

cluster image package show-repository (this commands also does not show anything...)

so do I need to enter below command to push the 9.5p6 package into repository...

cluster image package get -url mroot/etc/software/9.5p6_q_image.tgz

Regards
raj


_______________________________________________
Toasters mailing list
[email protected]<mailto:[email protected]>
http://www.teaparty.net/mailman/listinfo/toasters

_______________________________________________
Toasters mailing list
[email protected]
http://www.teaparty.net/mailman/listinfo/toasters