Re: hardware or software based disk ownership?

I think I may just be looking at a limit of the system. If an aggregate 
is already assigned to one SVM, can it also be assigned to another? That 
is, can two different SVMs access the same aggregate?

Output:

netapp4::> vserver modify -vserver scharp_vm_storage -aggr-list 
scharpdata,scharp_vm_storage

netapp4::> vserver show
                                Admin      Operational Root
Vserver     Type    Subtype    State      State       Volume Aggregate
----------- ------- ---------- ---------- ----------- ---------- ----------
netapp4     admin   -          -          -           -          -
netapp4-a   node    -          -          -           -          -
netapp4-b   node    -          -          -           -          -
scharp_kube data    default    running    running     scharp_ scharpdata
                                                       kube_root
scharp_vm_storage
             data    default    running    running     scharp_vm_ scharp_vm_
                                                       storage_ storage
                                                       root
scharpdata  data    default    running    running     scharpdata scharpdata
                                                       _root
6 entries were displayed.

netapp4::>

On 7/7/2020 2:06 PM, tmac wrote:
> Something may be getting lost here. Are you able to send any output?
>
> --tmac
>
> *Tim McCarthy, */Principal Consultant/
>
> *Proud Member of the #NetAppATeam <https://twitter.com/NetAppATeam>*
>
> *I Blog at TMACsRack <https://tmacsrack.wordpress.com/>*
>
>
>
>
> On Tue, Jul 7, 2020 at 4:47 PM Rue, Randy <[email protected] 
> <mailto:[email protected]>> wrote:
>
>     I was misremembering from my early days in pre-cluster mode.
>
>     Forget any mention of disk ownership :)
>
>     Can an aggregate be used by more than one SVM? If so, how? When I
>     try to
>     add the aggregate to the other SVM, the command returns without error
>     but vserver show still shows the SVMS and their assigned aggregates
>     unchanged.
>
>
>     On 7/7/2020 12:10 PM, John Stoffel wrote:
>     > Randy,
>     > Check your configuration, you need to assign the aggregates to the
>     > vservers.
>     >
>     >
>     >
>     >
>     https://library.netapp.com/ecmdocs/ECMP1196912/html/GUID-5255E7D8-F420-4BD3-AEFB-7EF65488C65C.html
>     >
>     > shows you the steps to take.
>     >
>     >        vserver show -fields aggr-list
>     >
>     >        vserver modify -vserver <vserver> -aggr-list
>     <aggr1>,<aggr2>[,aggrN]
>     >
>     > John
>     _______________________________________________
>     Toasters mailing list
>     [email protected] <mailto:[email protected]>
>     https://www.teaparty.net/mailman/listinfo/toasters
>

_______________________________________________
Toasters mailing list
[email protected]
https://www.teaparty.net/mailman/listinfo/toasters