Re: HP-UX NFSv3 and ONTAP

AFAIK dNFS was introduced in Oracle 11g (September 2009).

If this is really an Oracle 8i (August 2000, EOS Extended 2006), it 
doesn't have dNFS available.

You might want to check ancient TRs also and/or just make sure, the 
instructions apply to your version...


Sebastian


On 15.07.2020 15:54, Tim McCarthy wrote:
> Use OracleÂ’s DNFS client. Should be okay I would think.
>
> Get Outlook for iOS <https://aka.ms/o0ukef>
> ------------------------------------------------------------------------
> *From:* Toasters <[email protected]> on behalf of André M. 
> Clark <[email protected]>
> *Sent:* Wednesday, July 15, 2020 9:39:13 AM
> *To:* [email protected] <[email protected]>
> *Subject:* HP-UX NFSv3 and ONTAP
> I have a client that has an old HP-UX (11.23) server that currently 
> has FC mounts to an even older CX3. It has already been ruled out on 
> moving this workload to FCP on their ONTAP cluster (9.6P3) as the 
> system is outside of the IMT. What I am proposing to them is moving 
> this workload over to NFS and see if it would meet the very low 
> application requirements. The main workload is an Oracle 8i (8.17) 
> database that has extremely low transactions.
>
> My question is are there any gotchas or specific settings that should 
> be employed regarding NFS mounts and HPUX? I have reviewed TR-4067 
> (quickly) and KB and the two items that stuck out (qtree exports and 
> NFSv4) are items that I was not proposing on using. Anything else to 
> be aware of?
>
> Many thanks in advance
>
>
> Regards,
> André M. Clark
>
>
> _______________________________________________
> Toasters mailing list
> [email protected]
> https://www.teaparty.net/mailman/listinfo/toasters

_______________________________________________
Toasters mailing list
[email protected]
https://www.teaparty.net/mailman/listinfo/toasters