RE: SV: 2node system, migration to a new box?

Sami Kapanen <[email protected]>
Newsgroups gmane.comp.hardware.netapp
Message-ID <HE1PR0402MB2907F25018976B9870C746EF92939@HE1PR0402MB2907.eurprd04.prod.outlook.com>
We would be replacing all hardware at this time. Going to 2720.
Need to check this SVM DR.

sk

From: Sebastian Goetze <[email protected]>
Sent: maanantai 8. maaliskuuta 2021 13:10
To: Heino Walther <[email protected]>; Sami Kapanen <[email protected]>; [email protected]
Subject: Re: SV: 2node system, migration to a new box?


Well, there's also SVM DR, if the distance is too far, or there's no possibility to get switches.

Headswap with a 2520 might get tricky, because of the internal disks... depending on where you're going to...

(And CN1610 is Broadcom rebranded AFAIK)



Sebastian


On 08.03.2021 10:32, Heino Walther wrote:
Jo Sami

You would need to add your new cluster into your existing cluster.
You can only do this with cluster switches.  (I think you can do this with just about any 10G switch)
Personally I use NetApp CN1610 switches which is just Cisco Nexus swtches...

There is a procedure of how you go from your existing "switchless" cluster to a "switched cluster", and back again... (no down time)
When the two clusters are connected, you can move your volume and LIFs onto your new cluster nodes... once all data and LIFS have been migrated, you can remove the two old nodes from the cluster and convert back to switchless cluster.

You should be able to do all this without any down time.

If you only want to swap the heads and not the disks, you should also be able to do a "headswap" procedure...  again without any down time.... (netapp has a procedure for this as well)

/Heino

Fra: Toasters <[email protected]><mailto:[email protected]> på vegne af Sami Kapanen <[email protected]><mailto:[email protected]>
Dato: mandag, 8. marts 2021 kl. 10.09
Til: [email protected]<mailto:[email protected]> <[email protected]><mailto:[email protected]>
Emne: 2node system, migration to a new box?
We have 2node FAS2520 (no switches).
How to migrate SVMs to a new cluster? Want to preserve CIFS server names and IP addresses.
Last time we used 7MTT to do the migrations.. is there similar tool for cluster mode migrations?

br,
sk



_______________________________________________
Toasters mailing list
[email protected]<mailto:[email protected]>
https://www.teaparty.net/mailman/listinfo/toasters



_______________________________________________

Toasters mailing list

[email protected]<mailto:[email protected]>

https://www.teaparty.net/mailman/listinfo/toasters

_______________________________________________
Toasters mailing list
[email protected]
https://www.teaparty.net/mailman/listinfo/toasters
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.